L020K Clip Set Contents:

·         Loop size 3/16” Screw hole size 7/32” Clip to fasten wires to heater switch control lever assembly.    x 1

·         Loop size 5/16” Screw hole size 15/32” Clip to fasten fuel pipe to rear shock mount bolt.   x 1

·         Loop size 3/16”x 2 Screw hole size 11/32” Clip (double pipe style) to hold overflow pipes carb. to side of  engine produced from brass as original.   x 1

·         Loop size 1/2” Screw hole size 13/32” Clip to fasten heater (water) pipe to top of intake manifold.      x 2

·         Loop size 1/8” Screw hole size 13/32” Clip to fasten vacuum pipe to rear of head.  x 1

·         Loop size l/2” Screw hole size 9/32” Clip to house rubber buffer and fasten speedometer cable.            x 1

·         Loop size 3/16” Screw hole size 7/32” Brake pipe to RH battery rack, therm, pipe to body.  x 4

·         Loop size 1/4” Screw hole size 9/32” Clutch pipe attachment—alternate to early style half clip. x 2

·         Loop size 1/4” Screw hole size 11/32” Clutch pipe attachment—forward of master cylinder. x 1

·         Loop size 3/8” Screw hole size 7/32” Wiring harness forward, upper area of bonnet latch bulkhead.  x 3

·         Loop size 1/2” Screw hole size 9/32” Neg. battery cable to extra long floorboard screw rear of  RH

main floorboard.  x 1

·         Loop size 1/4” Screw hole size 7/32” Wiring harness to clips—RH, rear chassis, wheel arch area.      x 2

·         Loop size 1/2” Screw hole size 11/32” Wiring harness to wing bolts—inside engine bay area—RH side Headlamp/parking lamp cables to wing bolts  - bottom, front of wings.  x 4

·         Loop size 5/16” Screw hole size 11/32” Fuel pipe to heater box shelf/bulkhead area, later style.

Alternate to early style half clip.    x 2

·         Loop size 3/16” Screw hole size 11/32” Choke cable and brake pipe to master cylinder area, brake

pipe to rear (“pumpkin”), license lamp wiring to license mounting bracket.   x 4

·         Loop size 5/8” Screw hole size 11/32” Main harness to heater box shelf/bulkhead RH side. x 1

·         Loop size=5/8” Screw hole size 7/32”—Main harness to “firewall” inside engine bay.  x 2

·         Loop size l/8” Screw hole size 7/32”  Oil gauge pipe to heater box shelf and firewall.     x 2

·         Loop size 5/16” Screw hole size 7/32” Dipper switch wiring, emergency brake cable to RH battery rack.  x 2

·         Loop size 3/16” Screw hole size 9/32” Brake pipe to toe-board plate.   x 1

·         Loop size 3/8” x 2 Screw hole size 7/32” Battery cable and harness to RH underside of chassis.  x 6